Fix-A-Leak 1 Qt.

Price: $32.00

1 Review(s)

Part Number:

FAL-32

Availability:

In Stock

Write a Review

Quantity

Description
Customer Reviews

Under the same leak conditions Fix-A-Leak will out perform the rest.

Use 8 ounces per 1000 Gallons

FIX-A-LEAK
PLEASE NOTE: This item must ship ground it cannot go 2 Day Air or Overnight.

FIX-A-LEAK is a blended concentrated material designed to seal leaks in virtually any material.

FIX-A-LEAK can be applied for leaks in the spa and works equally well in the plumbing.

FIX-A-LEAK will seal holes 1/8" in diameter.

FIX-A-LEAK will form a permanent seal.

Use 1 quart per pool up to 22,000 gallons.
Do not use in excess of 1 quart per 5000 gallons of water.

Directions
- Shake Well Before Using -

Bypass FILTER MEDIA before adding FIX-A-LEAK to water.

Sand Filters:

set filter valve to recirculate.

Other Types:

remove cartridges DE elements from filter tank. Then proceed to circulate through empty tank.

With pump running on high speed add FIX-A-LEAK slowly through skimmer or in front of any other suction intake.

After adding FIX-A-LEAK allow pump to run for approximately 4-5 hours.

Continue to recirculate water until the leak has stopped.

After the leak has stopped and given the proper time to cure. (24-48hrs) Drain, clean and refill the spa

Treatment can be repeated if necessary.

Sand Filters:

Set filter valve to filter and resume normal operation. Backwash out unused FIX-A-LEAK as required.

Other Types:

Reinstall filter into tank and resume operation. Rinse out unused FIX-A-LEAK from filter as required.

*NOTE*

Never let cartridges or DE elements be left to dry before they are cleaned.

Suction Leaks
Suction Leaks are usually known by seeing air mixed with the water at the return fittings. In most cases suction lines only leak water when the filter pump is shut off. Normal Circulation will simply draw FIX-A-LEAK away from the leak and if the pump is shut off the material will simply not get to the leak. You must reverse the flow of water, to force the material through the leak under pressure. Preferably 5-10 psi. until the leak has stopped. When this has been achieved, gradually increase pressure to 15-25 psi. to insure a proper seal.

VERY IMPORTANT After sealing a suction line leak you must leave the suction off the repaired line for no less than 48 hours. FIX-A-LEAK requires time to cure and harden.

Miscellaneous Leaks
If you suspect a leak around fittings inside the spa (such as return fittings) lights, skimmer(s) or steps, etc, shut down pump. Apply FIX-A-LEAK directly to the leak using a squeeze bottle, similar to a ketchup bottle. Allow a minimum of 48 hours to cure before starting up circulation.

Rating Snapshot

Select a row below to filter reviews.

5 Stars

4 Stars

3 Stars

2 Stars

1 Stars

Average Customer Ratings

4.0

While the product did not fix the leak it did lessen the leak so I’m ordering another bottle and will try again.

Did you find this helpful?

Reviewed by: Diane from Alabama on 7/1/2023

Same Day Shipping If Ordered By

3:00 CST

Monday Thru Friday

$11.95 Flat Rate Shipping