0 Item(s) | Total: $0
0 item(s) Ships to Canada & Europe Security Seals

Gecko Control Box Excluding Heater 0202-205209

Gecko Control Box Excluding Heater 0202-205209
Price: $425.00


In Stock.
Part Number:0202-205209
Customer Reviews


Gecko 0202-205162

An Alternate Control Box is the New IN.YE-5 By Gecko. It is the next generation of controls and cost less. BDLYE5K200 - BDLYE5K450 or BDLYE5K353OP

Standard Features And Operations
Pump 1 Circuit 120V or 240V 2 Speed
Pump 2 Circuit 120V or 240V 1 Speed
Blower Circuit 120V or 240V 1 Speed
Circulation Pump 120V or 240V 24/7 Circulation
Ozone Circuit 120V or 240V Controlled By Filter Cycle
Heater N/A (See Options Below)
Light Circuit 12V 8' Cord with Bulb
Temperature Sensor Spa Wall 10' Long - Auto Reset
Overheat Sensor Heater Mount 2' Long - Auto Reset
Topside Control Not Included (See Options Below)
Warranty 2 Years
*The TSC-35 topside will operate Pump1, Pump2 and a Blower by moving a jumper on the circuit board.

Works with the Topside Controls Posted Below
Sold under both part numbers: 3-72-7074 & 0202-205162

Model & Options: SSPA-MP-P121-P211-B1-0-CP1-AU11-LS-H4.0-JJC-XXX
Click here For Model/Options Code Defined.

Schematic and Jumper Settings
Gecko SSPA-1 and SSPA-MP Spa Pack Service Manual
TSC-9-18-19 Topside Control Operation Instructions
TSC-35 Topside Control Operation Instructions

  • If operating 2 Pumps & Blower, K-35 topside must be used.
  • No replacement circuit boards for this control box.
  • Click here for more Gecko S-CLASS Control Boxes

* Installation instructions are on the back cover, please be sure to look at the jumper settings and wiring instructions for each pump, blower etc. Specifically the white wire to each one of these appliances. It is this wire that designates weather it will operate at 120 volts or 220 volts.

Automatic time-out on all outputs
Sensor failure detection
Ozone management
Programmable filter cycles
High-limit protection
Pressure switch failure detection
Current limiting option
Smart Winter Mode
Temp accuracy within 1F
Filter cycle overtemp protection

5 Stars
David recommended this board as a replacement for an obsolete board that fried. Changed jumper settings and re-routed one wire from the pre-configuration to accommodate a 240-V blower. Had to change one J & J connector, just re-using the old one, but it was all pretty much a common-sense changeover (as long as you do your homework). Everything working, everyone's happy...
Did you find this helpful?  1 of 1 Found Helpful
Reviewed by:  from Cypress, Tx. on 1/16/2017

Recently Viewed Items