Spa Care Center repairs all spa control boxes*, specializing in printed circuit board repairs. The cost to repair most circuit boards is around $145.00, we do give estimates before doing any repairs. Typically there is a 2 week turnaround after receiving the repair (15 business days). During the busy season; Spring and Fall, it can be up to 3 weeks. If you are interested in getting your spa controls repaired please refer to the instructions below. To get started with the repair process, please click the Repair Order
Form link below. A new window will pop up with a form to fill out. Please
read the information on the form carefully. Shipping Address:
Spa Repair
12176 E Luna Lane
Mayer AZ 86333 *We do not repair: Bathtub Controls, Watkins/HotSprings, BlueRidge, or any control manufactured in China.
Note: The two repair request we receive more then any other is "no heat
and no power". Many times when we receive these repairs they work fine
on our bench, we cannot do a thorough test for "no heat" if we do not
receive the heater and pressure switch. Pressure switches are the number
one cause for no heat as well as improper voltage to the control box
from the house. Please make sure that you have the proper voltage by
measuring across the L1 and L2 wires from the house
at the same time, measuring from L1 or L2 to ground does not give a
proper reading, also make sure all fuses have been checked. If you are
getting any error codes in the topside display, you may want to locate
the meaning/s and the steps to remedy at this link
Spa Side Error Codes.
|